How do you use Atmosrx?
To use this feature simply inhale while the cartridge is attached to your Nano Prime battery. Pre-Heat / Automatic Function: To active the Nano Prime’s Pre-heat function, press the power button (2) times in rapid succession. Once activated, the power button will begin to shine, showing that it is heating.
Why is my Atmos pen not working?
Make Sure Your Vape Pen Battery Is On An often-overlooked feature of the Atmos vaporizer batteries is that 5 rapid clicks of the power button will turn the device on and off. It’s possible you may have turned your battery off without even noticing it, causing it not to power your heating chamber.
How do you clean an Atmos micro pal?
Upkeeping the Atmos Micro Pal Carts can be easily attached and unscrewed, and the lack of any complicated or unnecessary parts allow easy access to all of the battery. Put simply, the battery can simply be wiped down with an alcohol wipe to keep it clean and well-maintained.
Why is my battery blinking 3 times?
Certain batteries will flash 3 times to indicate a short circuit. If the tank is screwed down too hard it can push the centre pin on the battery down just a tad and the connection is lost. Just check the battery isn’t screwed on too tight.
Why is my Atmos pen blinking?
This is often caused by a loose battery. If the battery is not screwed in properly, it won’t be able to fully charge and the indicator light will continue to blink. To fix this issue, unscrew the battery and re-screw it back in to make sure everything is firmly connected.
What is a micro pal?
The Micro-Pal is a convenient and discreet way to vape wax consistency products and thick oils. The Micro Pal is a variable voltage battery, giving you four optimized voltage settings, and it’s advanced pre-heat function makes vaping faster and easier than ever.
How do you put a micro pal cartridge in?
To load the included cartridge, follow these simple steps: • Unscrew the chamber cover from the cartridge. . Using a packing tool, apply your wax consistency product to the heating coil. Reattach the chamber cover completely before placing the cartridge into your Micro-Pal battery.
How long does it take to charge Atmos?
about 2-3 hours
The Atmos Jump plugs in via Micro-USB port and a full charging cycle takes about 2-3 hours. The 1200 mAh battery provides enough power for a lot of vaping.
Why does battery blink 10 times?
Dying battery: Most often, the vape pen will blink ten times when the battery is too low for proper vaping. To fix the issue, recharge the battery. Low voltage: If the battery is charged but the pen is still blinking, it could be due to a low voltage.
