What is Hayward freeze protection?
Freeze Protection: This function protects the pool, plumbing, and equipment against freeze damage. If Freeze Protection is enabled and the AIR temperature falls below the preset freeze protection temperature (see Filter Configuration), the Pro Logic will turn on the filter pump to circulate the water.
How does pool freeze protection work?
Freeze Protection Units allow pool and spa owners to set a desired temperature where their pump and heater will automatically turn on. Once the climate drops to the specified temperature, the Freeze Protection Unit kicks in. It turns on your pump and heater to keep the water moving, which prevents freeze expansion.
How do I put freeze protection on my pool?
We do recommend that you set the freeze temperature at 40-45 degrees just to be safe. During extremely harsh weather (low 20’s and windy) you might consider just leaving the pump running 24 hours per day until the weather gets back up into the upper 20’s.
What temperature do you set pool freeze?
You should have a freeze protection device that will automatically turn the pump on when the temperature drops to around 34 degrees. A freeze protector will keep your pool running as long as the temperature remains close to freezing.
How do I unlock my Hayward Pool remote?
Unlock Configuration Menu To unlock the Configuration Menu, repeatedly press the Menu button until “Configuration Menu” is shown in the Menu Display. Press and hold the Menu Display for 5 seconds. Refer to your pool control’s manual to determine what options are offered within the Configuration Menu.
Should I turn off pool pump when freezing?
Keep your pumps running at all times during freezing temperatures. Remove winterizing plugs from the pump, filter, heater and any other equipment that can be drained. Install a Freeze Protector, which is a device that circulates the pool water when temperatures are 38°F or below.
Will pool freeze if pump is running?
Be sure to run your pool pump continuously when temperatures are near or below freezing. You don’t need to run your heater, moving water will not freeze. Water feature pumps should be run and valves should be open. Alternately, you can cover and drain the pump and pipes.
Will pool freeze if pump running?
Follow the guidelines below to keep your pool safe during freezing temperatures. Be sure to run your pool pump continuously when temperatures are near or below freezing. You don’t need to run your heater, moving water will not freeze. Alternately, you can cover and drain the pump and pipes.
Will my pool freeze if it’s running?
Can a pool freeze with pump running?
If your pool equipment isn’t winterized, water can freeze inside of your pump, filter or heater damaging these components so it’s important to keep water flowing through your pool’s system the entire time the temperature is freezing.
How does the freefreeze protection work?
Freeze protection is controlled by the automation controller (Omnilogic) on my pool and the way it works is that when the temp falls below a pre-set limit, the pump is automatically turned on. The pump is turned OFF by the normal run schedule (assuming the temp is higher than the limit).
What is the freeze protect on a pool pump for?
The freeze protect is only for the drive not for the water in the pool. In the early models it may have been called Freeze protect but it was changed to Low Temp. Here is how to change it in the configuration menu of the pump.
What is a Hayward Pro Logic pool controller?
SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 2 Introduction The Hayward Pro Logic is a multifunction pool controller used to fully manage your pool/spa sys- tem. The Pro Logic can control pumps, valves, lighting, heaters, and chlorination.
Should I Turn Off the freeze protection on my Ecostar?
Disable the freeze protection on the EcoStar as you will not need it. Believe it or not Lancaster can have some freezing temps once in a while. Do not rely on the EcoStar to be the freeze protection for your pool, as it was not meant for that purpose. It is there to protect the drive.